Home › ENGINE · 3UR-FE › ENGINE CONTROL SYSTEM › AIR PUMP HEATER RELAY

AIR PUMP HEATER RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE AIR PUMP HEATER RELAY (AI HTR)
  1. Remove the air pump heater relay from the engine room relay block.



2. INSPECT AIR PUMP HEATER RELAY (AI HTR)


B060778E19
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    When no battery voltage is applied to terminals 1 and 2
    10 kΩ or higher
    When battery voltage is applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the relay.



3. INSTALL AIR PUMP HEATER RELAY