WATER PUMP > ON-VEHICLE INSPECTION |
| 1. INSPECT COOLANT LEAK |
Visually inspect the engine compartment for the following conditions.
There is a large amount of coolant in the engine compartment or on the underside of the hood near the fan and generator V belt.
Liquid coolant is dripping from around the water pump.
The coolant level in the reservoir is below the L line and there are traces of leakage around the water pump.
Inspect the area around the water pump.
![]() |
Press the thin paper towel against the coolant (solid matter) adhering to the drain hole or the edge of the drain hole, and check the condition of the thin paper towel.
| 2. INSPECT WATER PUMP ASSEMBLY |
Remove the fan and generator V belt (Click here).
![]() |
Turn the pulley and check that the water pump bearing moves smoothly and quietly.
If necessary, replace the water pump.
Install the fan and generator V belt (Click here).