LIN COMMUNICATION SYSTEM > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Communication D-Door Motor | Connection status between power window regulator motor (for driver side) and main body ECU / OK or STOP | OK: Connection STOP: No connection | When there is a malfunction, a DTC is stored. |
| Communication P-Door Motor | Connection status between power window regulator motor (for front passenger side) and main body ECU / OK or STOP | OK: Connection STOP: No connection | When there is a malfunction, a DTC is stored. |
| Communication Slide Roof | Connection status between sliding roof ECU and main body ECU / OK or STOP | OK: Connection STOP: No connection | When there is a malfunction, a DTC is stored. |
| Communication Master SW | Connection status between power window ECU (master switch) and main body ECU / OK or STOP | OK: Connection STOP: No connection | When there is a malfunction, a DTC is stored. |
| Number of DTC | Number of trouble codes / Min.: 0, Max.: 255 | Number of DTCs | - |