Home › BODY ELECTRICAL › METER › COMBINATION METER

COMBINATION METER > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    E145052
  1. Detach the 4 claws.



    E145049
  1. for Column Shift Type:
    Move the shift lever to the S position.

  1. Detach the 12 clips.

  1. Disconnect the connectors and clamps.



  1. Remove the wire harness from the slots, and then remove the finish panel.


    E145053E01



4. REMOVE COMBINATION METER ASSEMBLY


    E141677
  1. Remove the 4 screws.



    E141678
  1. Disconnect the connector and clamp, and remove the combination meter.