FOG LIGHT ASSEMBLY > ADJUSTMENT |
| 1. VEHICLE PREPARATION FOR FOG LIGHT AIM |
Prepare the vehicle:
| 2. PREPARATION FOR FOG LIGHT AIMING |
![]() |
Prepare the vehicle according to the following conditions:
| *a | 90° |
| *b | 7.62 or 3 m |
Prepare a piece of thick white paper approximately 2.0 m (6.56 ft.) (height) x 4.0 m (13.1 ft.) (width) to use as a screen.
Draw a vertical line down the center of the screen (V line).
Set the screen as shown in the illustration.

![]() |
Draw base lines (H line, V LH, V RH lines) on the screen as shown in the illustration.
| *a | V LH Line |
| *b | V Line |
| *c | V RH Line |
| *d | H Line |
| *e | Ground |
H Line (Fog light height):
Draw a horizontal line across the screen so that it passes through the center marks. The H line should be at the same height as the fog light bulb center marks of the fog lights.
V LH Line, V RH Line (Center mark position of left-hand (LH) and right-hand (RH) fog lights):
Draw 2 vertical lines so that they intersect the H line at each center mark.
| 3. FOG LIGHT AIMING INSPECTION |
Cover the fog light or disconnect the connector of the fog light on the opposite side to prevent light from the fog light that is not being inspected from affecting the fog light aiming inspection.
Start the engine.
Turn on the fog light and check if the cutoff line falls within the specified area in the following illustration.

| 4. FOG LIGHT AIMING ADJUSTMENT |
![]() |
Adjust the aim vertically.
| *1 | Aiming Screw |