Home › BODY ELECTRICAL › LIGHTING › FOG LIGHT ASSEMBLY

FOG LIGHT ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH side.
  2. The procedures listed below are for the LH side.



1. INSTALL FOG LIGHT ASSEMBLY LH


    E144974E01
  1. for Steel Type Bumper:

    1. Attach the 2 claws to install the fog light.

    2. Attach the tabs on the fog light aiming screw to the bumper.

    3. Connect the connector.



    E144957E01
  1. for Resin Type Bumper:

    1. Attach the 2 claws to install the fog light.

    2. Attach the tabs on the fog light aiming screw to the bumper.

    3. Connect the connector.



2. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH