Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH

CRUISE CONTROL MAIN SWITCH > INSPECTION

for Preparation Click here



1. INSPECT CRUISE CONTROL MAIN SWITCH


  1. Measure the resistance according to the value(s) in the table below.


    E144729E01


    Standard resistance:

    Tester Connection
    Switch Condition
    Specified Condition
    1 (ECC) - 3 (CCS)
    Neutral
    10 kΩ or higher
    +RES
    235 to 245 Ω
    -SET
    620 to 640 Ω
    CANCEL
    1510 to 1570 Ω
    Main Switch OFF
    10 kΩ or higher
    Main Switch ON
    Below 1 Ω

    If the result is not as specified, replace the cruise control main switch.