CAN COMMUNICATION SYSTEM > Combination Meter ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Combination Meter ECU Communication Stop Mode | Either condition is met:
|
|

| 1.CHECK HARNESS AND CONNECTOR (COMBINATION METER ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the J28 combination meter ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J28-40 (E1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| J28-18 (B) - Body ground | Always | 11 to 14 V |
| J28-20 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | ||
| ||