AIR CONDITIONING SYSTEM (for Manual Air Conditioning System) > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Warm up the engine.
Turn the ignition switch OFF.
Connect the Techstream to the DLC3.
Turn the ignition switch ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / (desired menu) / Data List.
According to the display on tester, read the "Data List".
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Ambient Temp Sensor | Ambient temperature sensor / Min.: -23.3°C (-9.94°F) Max.: 65.95°C (150.71°F) | Actual ambient temperature is displayed | Open in circuit: -23.3°C (-9.94°F) Short in circuit: 65.95°C (150.71°F) |
| Adjusted Ambient Temp | Adjusted ambient temperature / Min.: -30.8°C (-23.44°F) Max.: 50.8°C (123.44°F) | Adjusted ambient temperature is displayed | - |
| Evaporator Fin Thermistor | Evaporator fin thermistor / Min.: -29.7°C (-21.46°F) Max.: 59.55°C (139.19°F) | Actual evaporator temperature is displayed | Open in circuit: -29.7°C (-21.46°F) Short in circuit: 59.55°C (139.19°F) |
| Engine Coolant Temp | Engine coolant temperature / Min.: 1.3°C (34.34°F) Max.: 90.55°C (194.99°F) | Actual engine coolant temperature is displayed while engine is warmed up | - |
| Air Mix Servo Targ Pulse (D) | Driver side air mix servo motor target pulse / Min.: 0, Max.: 255 | MAX. COLD: 5 (pulse) MAX. HOT: 104 (pulse) | - |
| Air Mix Servo Targ Pulse (P) | Passenger side air mix servo motor target pulse / Min.: 0, Max.: 255 | MAX. COLD: 105 (pulse) MAX. HOT: 6 (pulse) | - |
| Air Outlet Servo Pulse (D) | Driver side air outlet servo motor target pulse / Min.: 0, Max.: 255 | FACE: 9 (pulse) MID: 25 (pulse) B/L: 32 (pulse) MID: 39 (pulse) FOOT: 56 (pulse) MID: 77 (pulse) FOOT/DEF: 83 (pulse) MID: 91 (pulse) DEF: 97 (pulse) | - |
| Air Inlet Damper Targ Pulse | Air inlet damper target pulse / Min.: 0, Max.: 255 | REC: 7 FRS: 28 | - |
| Ambient Temperature Shift | Ambient temperature shift / 3C incr, 2C incr, 1C incr, Normal, 1C decr, 2C decr or 3C decr | Customized value will be displayed | - |
| Number of Trouble Codes | Number of trouble codes / Min.: 0, Max.: 255 | Number of DTCs will be displayed | - |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| A/C Signal | Air conditioning switch signal / ON or OFF | ON: Air conditioning ON OFF: Air conditioning OFF | - |
| PERFORM ACTIVE TEST |
Connect the Techstream to the DLC3.
Turn the ignition switch ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Air Conditioner / Active Test.
According to the display on the Techstream, perform the "Active Test".
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Magnetic Clutch Relay | Magnetic clutch relay | ON or OFF | - |
| Defogger Relay (Rear) | Defogger relay | ON or OFF | - |
| Mirror Heater Relay | Mirror heater relay | ON or OFF | - |
| Deicer Relay (Front) | Deicer relay | ON or OFF | - |
| Air Mix Servo Targ Pulse (D) | Driver side air mix servo motor pulse | Min.: 5, Max.: 104 | - |
| Air Mix Servo Targ Pulse (P) | Passenger side air mix servo motor pulse | Min.: 6, Max.: 105 | - |
| Air Outlet Servo Pulse (D) | Driver side air outlet servo motor pulse | Min.: 9, Max.: 97 | - |
| Air Inlet Damper Targ Pulse | Air inlet damper target pulse | Min.: 7, Max.: 28 | - |