Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING AMPLIFIER

AIR CONDITIONING AMPLIFIER > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



3. REMOVE FRONT DOOR SCUFF PLATE RH
  1. for Regular Cab:
    Remove the front door scuff plate .

  1. for Double Cab:
    Remove the front door scuff plate .

  1. for CrewMax:
    Remove the front door scuff plate .



4. REMOVE COWL SIDE TRIM BOARD RH
  1. for Regular Cab:
    Remove the cowl side trim board .

  1. for Double Cab:
    Remove the cowl side trim board .

  1. for CrewMax:
    Remove the cowl side trim board .



5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. for Column Shift Type:
    Remove the No. 2 instrument panel under cover sub-assembly .

  1. for Floor Shift Type:
    Remove the No. 2 instrument panel under cover sub-assembly .



6. REMOVE INSTRUMENT SIDE PANEL RH
  1. for Column Shift Type:
    Remove the instrument side panel .

  1. for Floor Shift Type:
    Remove the instrument side panel .



7. REMOVE LOWER INSTRUMENT PANEL
  1. for Column Shift Type:
    Remove the lower instrument panel .

  1. for Floor Shift Type:
    Remove the lower instrument panel .



8. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
  1. for Column Shift Type:
    Remove the No. 2 instrument panel airbag assembly .

  1. for Floor Shift Type:
    Remove the No. 2 instrument panel airbag assembly .



9. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH
  1. for Column Shift Type:
    Remove the instrument panel finish panel .

  1. for Floor Shift Type:
    Remove the instrument panel finish panel .



10. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY


E142372
  1. Remove the screw and duct.



11. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY


E191720E01
  1. for Manual Air Conditioning System:
    Disconnect the 2 connectors.

  1. for Automatic Air Conditioning System:
    Disconnect the 3 connectors.

  1. Remove the 2 screws and amplifier.