Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING RESET SWITCH

TIRE PRESSURE WARNING RESET SWITCH > INSPECTION

for Preparation Click here



1. CHECK TIRE PRESSURE WARNING RESET SWITCH


    C158396E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    ON (Switch is pressed and held)
    Below 1 Ω
    OFF (Switch is not pressed)
    10 kΩ or higher

    If the result is not as specified, replace the switch.