Home › BODY › EXTERIOR › FRONT BUMPER (for Steel Type Bumper)

FRONT BUMPER (for Steel Type Bumper) > DISASSEMBLY

for Preparation Click here



1. REMOVE FRONT LOWER BUMPER RETAINER SUB-ASSEMBLY


  1. Remove the 10 clips and retainer.


    B165509



2. REMOVE FRONT VALANCE PANEL


  1. Remove the 10 bolts, 2 nuts and valance panel.


    B165510



3. REMOVE FRONT BUMPER HOLE COVER LH (w/o Fog Light)


B165512
  1. Detach the 3 claws and remove the hole cover.



4. REMOVE FRONT BUMPER HOLE COVER RH (w/o Fog Light)

HINT:
Use the same procedures described for the LH side.



5. REMOVE FOG LIGHT ASSEMBLY LH (w/ Fog Light)


E144974
  1. Detach the 2 claws and remove the fog light.



6. REMOVE FOG LIGHT ASSEMBLY RH (w/ Fog Light)

HINT:
Use the same procedures described for the LH side.



7. REMOVE FOG LIGHT MOUNTING BRACKET LH (w/ Fog Light)


B165511
  1. Detach the 3 claws and remove the bracket.



8. REMOVE FOG LIGHT MOUNTING BRACKET RH (w/ Fog Light)

HINT:
Use the same procedures described for the LH side.



9. REMOVE NO. 1 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System)


    E134853
  1. While pushing down on the lever with a finger to release the one claw, detach the claw on the other side to remove the ultrasonic sensor.

    HINT:
    The type of claw on the top and bottom of the sensor are different. Observe the claws carefully before removing the sensor.



10. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System)


    E146464
  1. Detach the 2 claws and remove the sensor retainer from the front bumper.