Home › BODY › EXTERIOR › FRONT BUMPER (for Resin Type Bumper)

FRONT BUMPER (for Resin Type Bumper) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE FRONT END PANEL LH


B165496
  1. Using a clip remover, remove the 2 clips.

  1. Detach the 2 pins and remove the panel.



4. REMOVE FRONT END PANEL RH

HINT:
Use the same procedures described for the LH side.



5. REMOVE FRONT BUMPER COVER


B165629E01
  1. Using a screwdriver, remove the 2 pin hold clips.

    HINT:
    Use the same procedures for the RH side and LH side.

  1. Using a clip remover, remove the 2 clips.

    HINT:
    Use the same procedures for the RH side and LH side.

  1. Put protective tape around the bumper cover.

  1. Using a clip remover, remove the 8 clips.



  1. Remove the 9 screws.


    B165630E01



  1. Detach the 4 claws and remove the bumper cover.


    B165636

  1. w/ Fog Light:
    Disconnect the fog light connectors and remove the bumper cover.

  1. w/ Intuitive Parking Assist System:
    Disconnect the ultrasonic sensor connectors and remove the bumper cover.



6. REMOVE FRONT BUMPER SIDE SUPPORT LH


B165631
  1. Remove the 2 screws.

  1. Detach the 3 clips and remove the side support.



7. REMOVE FRONT BUMPER SIDE SUPPORT RH

HINT:
Use the same procedures described for the LH side.



8. REMOVE FRONT UPPER CENTER BUMPER RETAINER


  1. Remove the 6 nuts and retainer.


    B165504



9. REMOVE FRONT BUMPER END RETAINER LH


B165505
  1. Remove the 3 nuts and retainer.



10. REMOVE FRONT BUMPER END RETAINER RH

HINT:
Use the same procedures described for the LH side.



11. REMOVE FRONT BUMPER REINFORCEMENT


  1. Remove the 6 nuts and reinforcement.


    B165507



12. REMOVE FRONT NO. 2 BUMPER EXTENSION SUB-ASSEMBLY LH


B165508
  1. Remove the 4 nuts and bumper extension.



13. REMOVE FRONT NO. 2 BUMPER EXTENSION SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.