Home › BODY › EXTERIOR › FRONT BUMPER (for Resin Type Bumper)

FRONT BUMPER (for Resin Type Bumper) > DISASSEMBLY

for Preparation Click here



1. REMOVE FRONT BUMPER HOLE COVER LH (w/o Fog Light)


B165634
  1. Remove the 2 screws.

  1. Detach the 3 claws and remove the hole cover.



2. REMOVE FRONT BUMPER HOLE COVER RH (w/o Fog Light)

HINT:
Use the same procedures described for the LH side.



3. REMOVE FOG LIGHT ASSEMBLY LH (w/ Fog Light)


E144957
  1. Detach the 2 claws and remove the fog light.



4. REMOVE FOG LIGHT ASSEMBLY RH (w/ Fog Light)

HINT:
Use the same procedures described for the LH side.



5. REMOVE FOG LIGHT MOUNTING BRACKET LH (w/ Fog Light)


B165635
  1. Remove the 2 screws.

  1. Detach the 3 claws and remove the bracket.



6. REMOVE FOG LIGHT MOUNTING BRACKET RH (w/ Fog Light)

HINT:
Use the same procedures described for the LH side.



7. REMOVE FRONT VALANCE PANEL


  1. Remove the 10 bolts, 2 nuts and panel.


    B165632E01



8. REMOVE FRONT FENDER LINER BRACKET LH


B165633
  1. Detach the 2 claws and remove the bracket.



9. REMOVE FRONT FENDER LINER BRACKET RH

HINT:
Use the same procedures described for the LH side.



10. REMOVE NO. 1 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System)


    E134853
  1. While pushing down on the lever with a finger to release the one claw, detach the claw on the other side to remove the ultrasonic sensor.

    HINT:
    The type of claw on the top and bottom of the sensor are different. Observe the claws carefully before removing the sensor.



11. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System)


    E146464
  1. Detach the 2 claws and remove the sensor retainer from the front bumper.