REAR BUMPER (for Steel Type Bumper) > INSTALLATION |
| 1. INSTALL NO. 3 WIRE FRAME (w/ Trailer Towing System) |
![]() |
for 4 Pin Type:
Install the No. 3 wire frame.
Install the wire frame with the 2 bolts.
Attach the 2 clamps.
Connect the connector.
![]() |
for 4 Pin and 7 Pin Type:
Install the No. 3 wire frame.
Install the wire frame with the 2 bolts.
Attach the 2 clamps.
Connect the connector.
| 2. INSTALL REAR BUMPER BAR |
Install the bumper bar with the 6 bolts.
Install the 2 bumper bar reinforcements with the 4 bolts.

w/ Intuitive Parking Assist System:
Connect the connectors and clamps, as shown in the illustration.

| 3. INSTALL REAR BUMPER PLATE LH |
![]() |
Attach the 4 clips to install the bumper pad.
| 4. INSTALL REAR BUMPER PLATE RH |
| 5. INSTALL REAR BUMPER PAD SUB-ASSEMBLY |
Attach the 14 clips to install the bumper pad.
Install the clip.

| 6. INSTALL LICENSE PLATE LIGHT ASSEMBLY LH |
![]() |
Attach the claw to install the license plate light.
Install the screw.
| 7. INSTALL LICENSE PLATE LIGHT ASSEMBLY RH |
| 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |