Home › BODY › EXTERIOR › REAR BUMPER (for Steel Type Bumper)

REAR BUMPER (for Steel Type Bumper) > REMOVAL

for Preparation Click here



1. REMOVE PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE LICENSE PLATE LIGHT ASSEMBLY LH


B166101
  1. Remove the screw.

  1. Detach the claw and remove the license plate light.



4. REMOVE LICENSE PLATE LIGHT ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



5. REMOVE REAR BUMPER PAD SUB-ASSEMBLY
  1. Remove the clip.



  1. Detach the 14 clips and remove the rear bumper pad.

    HINT:
    Detach the clips from the backside of the rear bumper.



    B166111



6. REMOVE REAR BUMPER PLATE LH


B166112
  1. Detach the 4 clips and remove the rear bumper plate.

    HINT:
    Detach the clips from the backside of the rear bumper.



7. REMOVE REAR BUMPER PLATE RH

HINT:
Use the same procedures described for the LH side.



8. REMOVE REAR BUMPER BAR


  1. w/ Intuitive Parking Assist System:
    Disconnect the connectors and clamps shown in the illustration.


    B166116

  1. Remove the 4 bolts and 2 bumper bar reinforcements.



  1. Remove the 6 bolts and bumper bar.


    B166113E01



9. REMOVE NO. 3 WIRE FRAME (w/ Trailer Towing System)


B166115
  1. for 4 Pin Type:
    Remove the No. 3 wire frame.

    1. Disconnect the connector.

    2. Detach the 2 clamps.

    3. Remove the 2 bolts and wire frame.



    B166114
  1. for 4 Pin and 7 Pin Type:
    Remove the No. 3 wire frame.

    1. Disconnect the connector.

    2. Detach the 2 clamps.

    3. Remove the 2 bolts and wire frame.