Home › BODY › EXTERIOR › REAR BUMPER (for Resin Type Bumper)

REAR BUMPER (for Resin Type Bumper) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 3 WIRE FRAME (w/ Trailer Towing System)


B166106
  1. Install the wire frame with the 2 bolts.

    Torque:
    8.3 N*m{ 85 kgf*cm , 73 in.*lbf }

  1. Attach the clamp.

  1. Connect the connector.



2. INSTALL REAR BUMPER SIDE EXTENSION SUB-ASSEMBLY LH


B166105
  1. Install the side extension with the 3 screws and bolt.



3. INSTALL REAR BUMPER SIDE EXTENSION SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



4. INSTALL REAR NO. 1 BUMPER SUPPORT


B166104
  1. Install the bumper support.



5. INSTALL REAR BUMPER PAD SUB-ASSEMBLY


B166103
  1. Install the bumper pad with the 6 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }



6. INSTALL REAR BUMPER COVER
  1. Attach the 4 claws to install the bumper cover.

  1. Install the 4 bolts and 2 nuts.

    Torque:
    for bolt:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }
    for nut:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }



  1. Install the 2 clips and 4 screws.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }



    B166102



  1. w/ Intuitive Parking Assist System:
    Connect the connector and clamps shown in illustration.


    B166117



7. INSTALL LICENSE PLATE LIGHT ASSEMBLY LH


B166101
  1. Attach the claw to install the license plate light.

  1. Install the screw.



8. INSTALL LICENSE PLATE LIGHT ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL