Home › BODY › EXTERIOR › REAR BUMPER (for Resin Type Bumper)

REAR BUMPER (for Resin Type Bumper) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE LICENSE PLATE LIGHT ASSEMBLY LH


B166101
  1. Remove the screw.

  1. Detach the claw and remove the license plate light.



4. REMOVE LICENSE PLATE LIGHT ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



5. REMOVE REAR BUMPER COVER


  1. w/ Intuitive Parking Assist System:
    Disconnect the connectors and clamps shown in illustration.


    B166117

  1. Remove the 2 clips and 4 screws.

  1. Remove the 4 bolts and 2 nuts.



  1. Detach the 4 claws and remove the rear bumper cover.


    B166102



6. REMOVE REAR BUMPER PAD SUB-ASSEMBLY


B166103
  1. Remove the 6 bolts and bumper pad.



7. REMOVE REAR NO. 1 BUMPER SUPPORT


B166104
  1. Remove the bumper support.



8. REMOVE REAR BUMPER SIDE EXTENSION SUB-ASSEMBLY LH


B166105
  1. Remove the 3 screws, bolt and side extension.



9. REMOVE REAR BUMPER SIDE EXTENSION SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



10. REMOVE NO. 3 WIRE FRAME (w/ Trailer Towing System)


B166106
  1. Disconnect the connector.

  1. Detach the clamp.

  1. Remove the 2 bolts and wire frame.