FRONT DOOR BELT MOULDING (for CrewMax) > REMOVAL |
| 1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH |
![]() |
Using a screwdriver, detach the 4 claws and remove the inside handle bezel.
| 2. REMOVE FRONT UPPER ARMREST BASE PANEL LH |
![]() |
Using a screwdriver, detach the 2 clips and front armrest upper base panel.
Disconnect the connectors.
| 3. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH |
![]() |
Detach the 3 clips and remove the front lower door frame bracket garnish.
| 4. REMOVE FRONT DOOR ARMREST COVER LH |
| 5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH |
![]() |
Remove the 2 screws.
Using a clip remover, remove the clip.
Detach the 9 clips and remove the trim cover. Then disconnect the connector.
![]() |
Disconnect the 2 cables from the inside handle.
Remove the inside handle.
| 6. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH |
![]() |
w/ Power Mirror Control System:
Disconnect the connector labeled A.
Remove the 3 nuts.
Detach the claw and remove the outer rear view mirror.
| 7. REMOVE FRONT OUTER DOOR GLASS WEATHERSTRIP ASSEMBLY LH |
![]() |
Put protective tape around the weatherstrip outer.
Using a moulding remover, detach the claw and remove the weatherstrip.