Home › BODY › EXTERIOR › REAR DOOR BELT MOULDING (for Double Cab)

REAR DOOR BELT MOULDING (for Double Cab) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. INSTALL REAR OUTER DOOR GLASS WEATHERSTRIP LH


B165862
  1. Attach the claw to install the weatherstrip.



2. INSTALL REAR INNER DOOR GLASS WEATHERSTRIP LH


3. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    B165684E03
  1. Connect the 2 cables to the inside handle.

  1. Attach the inside handle's knob to the door trim board.



    B166244E01
  1. Attach the 9 clips to install the door trim board.

  1. Install the inside handle and door trim board to the door trim panel with the screw.

  1. Install the door trim board to the door panel with the screw

  1. Attach the clip.



4. INSTALL REAR DOOR ARMREST COVER LH


5. INSTALL REAR DOOR FRAME GARNISH LH


    B167090
  1. Attach the 4 clips to install the rear door frame garnish.



6. INSTALL REAR UPPER DOOR ARMREST BASE PANEL LH


    B168094
  1. Connect the connector.

  1. Attach the 2 clips to install the rear upper door armrest base panel.



7. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH


    B168093
  1. Attach the 4 claws to install the bezel plug.