Home › BODY › EXTERIOR › REAR DOOR BELT MOULDING (for Double Cab)

REAR DOOR BELT MOULDING (for Double Cab) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH


    B166242
  1. Using a screwdriver, detach the 4 claws and remove the inside handle bezel.

    HINT:
    Tape the screwdriver tip before use.



2. REMOVE REAR UPPER DOOR ARMREST BASE PANEL LH


    B166243
  1. Using a screwdriver, detach the 2 clips and rear upper door armrest base panel. Then disconnect the connector.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE REAR DOOR FRAME GARNISH LH


    B167090
  1. Detach the 4 clips and remove the rear door frame garnish.



4. REMOVE REAR DOOR ARMREST COVER LH


5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    B166244E01
  1. Remove the 2 screws.

  1. Using a clip remover, remove the clip.

  1. Detach the 9 clips and remove the trim cover. Then disconnect the connector.



    B165654E01
  1. Disconnect the 2 cables from the inside handle.



6. REMOVE REAR INNER DOOR GLASS WEATHERSTRIP LH


7. REMOVE REAR OUTER DOOR GLASS WEATHERSTRIP LH


B165861E01
  1. Put protective tape around the weatherstrip outer.

  1. Using a moulding remover, detach the claw and remove the weatherstrip.