EFI RELAY > ON-VEHICLE INSPECTION |
| 1. INSPECT INTEGRATION RELAY (EFI RELAY) |

| *a | Integration Relay (Unit E) Inner Diagram | - | - |
Measure the resistance of the EFI fuse.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| EFI fuse | Always | Below 1 Ω |
![]() |
Measure the resistance of the EFI relay circuit.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1C-1 - 1B-4 | When battery voltage is not applied between 1B-2 and 1B-3 | 10 kΩ or higher |
| When battery voltage is applied between 1B-2 and 1B-3 | Below 1 Ω | |
| 1C-1 - 1B-5 | When battery voltage is not applied between 1B-2 and 1B-3 | 10 kΩ or higher |
| When battery voltage is applied between 1B-2 and 1B-3 | Below 1 Ω |
| *a | Component without harness connected (Integration Relay) |