IGNITION RELAY NO. 2 > ON-VEHICLE INSPECTION |
| 1. INSPECT INTEGRATION RELAY (IG2) |

| *a | Integration Relay (Unit E) Inner Diagram | - | - |
Measure the resistance of the IG2 MAIN fuse.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| IG2 MAIN fuse | Always | Below 1 Ω |
![]() |
Measure the resistance of the ignition relay No. 2 (IG2) circuit.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1C-1 - 1B-8 | When battery voltage is not applied between 1B-6 and 1B-7 | 10 kΩ or higher |
| When battery voltage is applied between 1B-6 and 1B-7 | Below 1 Ω |
| *a | Component without harness connected (Integration Relay) |