Home › ENGINE · 1GR-FE › STARTING › ACC RELAY

ACC RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT MAIN BODY ECU (ACC RELAY)


  1. Measure the resistance of the ACC relay circuit.



    1. Measure the resistance according to the value(s) in the table below.


      A160907E02


      Text in Illustration 
      *a
      Component without harness connected
      (Main Body ECU)
      -
      -

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      DD47 - DD8
      When battery voltage is not applied between DD45 and DD62
      10 kΩ or higher
      When battery voltage is applied between DD45 and DD62
      Below 1 Ω

      If the result is not as specified, replace the main body ECU.