Home › BODY › EXTERIOR › REAR BUMPER (for Resin Type Bumper)

REAR BUMPER (for Resin Type Bumper) > REASSEMBLY

for Preparation Click here



1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System)


    E146471E01
  1. Align the keyhole and protrusion as shown in the illustration.

  1. Install the sensor retainer to the rear bumper.

    NOTICE:
    Do not damage the bumper with the protrusion when installing the retainer.



2. INSTALL NO. 1 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System)


    E146472
  1. Attach the 2 claws to install the ultrasonic sensor.



3. INSTALL NO. 2 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System)


    E146473E01
  1. Align the keyhole and protrusion as shown in the illustration.

  1. Install the sensor retainer to the rear bumper.

    NOTICE:
    Do not damage the bumper with the protrusion when installing the retainer.



4. INSTALL NO. 2 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System)


    E146466
  1. Attach the 2 claws to install the ultrasonic sensor.



5. INSTALL REAR BUMPER SIDE RETAINER LH


B166107
  1. Install the retainer with the 4 clips.



6. INSTALL REAR BUMPER SIDE RETAINER RH

HINT:
Use the same procedures described for the LH side.