LIGHTING SYSTEM > DRL Relay Circuit |

| 1.CHECK HARNESS AND CONNECTOR (TURN SIGNAL FLASHER - MAIN BODY ECU) |
![]() |
Disconnect the J29 relay connector.
Disconnect the J3 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J29-5 (DRL) - J3-8 (DRL) | Always | Below 1 Ω |
| J29-5 (DRL) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK MAIN BODY ECU |
![]() |
Disconnect the ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 8 (DRL) - Body ground | Ignition switch ON | 11 to 14 V |
| Ignition switch OFF | Below 1 V |
|
| ||||
| OK | ||
| ||