LIGHTING SYSTEM > Cargo Light Circuit |

| 1.INSPECT FUSE (CARGO) |
Remove the CARGO LP fuse from the main body ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| CARGO LP fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.PERFORM ACTIVE TEST USING TECHSTREAM (CARGO LIGHT) |
Operate the Techstream according to the steps on the display and select "Active Test".
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Cargo Lgt | Cargo light | ON or OFF | Cargo light switch is DOOR or ON |
|
| ||||
| OK | ||
| ||
| 3.READ VALUE USING TECHSTREAM (CARGO LIGHT SWITCH) |
Operate the Techstream according to the display and select the "Data List".
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Cargo Light | Cargo light switch signal / ON or OFF | ON: Cargo light switch ON OFF: Cargo light switch OFF | - |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (CARGO LIGHT - BATTERY AND BODY GROUND) |
![]() |
Disconnect the P8 light connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| P8-3 (DL) - Body ground | Cargo light switch ON | 11 to 14 V |
| Cargo light switch DOOR, door is open | ||
| Cargo light switch OFF | Below 1 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| P8-1 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||
| 5.INSPECT CARGO LIGHT SWITCH |
![]() |
Remove the cargo light switch (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 5 (FCTY) - 9 (FLON) | Cargo light switch ON | Below 1 Ω |
| Cargo light switch DOOR | ||
| Cargo light switch OFF | 10 kΩ or higher | |
| 10 (FLMP) - 7 (E) | Cargo light switch ON | Below 1 Ω |
| Cargo light switch DOOR | 10 kΩ or higher | |
| Cargo light switch OFF |
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the J3 and J4 ECU connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| J2-14 (CGLP) - Body ground | Cargo light switch ON or DOOR | 11 to 14 V |
| Cargo light switch OFF | Below 1 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| J3-9 (CGSW) - Body ground | Cargo light switch ON | Below 1 Ω |
| Cargo light switch DOOR or OFF | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||