Home › BODY › SEAT › FRONT SEAT ASSEMBLY (for Fold Down Seat Type)

FRONT SEAT ASSEMBLY (for Fold Down Seat Type) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



3. REMOVE INNER FRONT SEAT TRACK COVER RH REAR
  1. Operate the seat track adjusting handle to move the seat to the foremost position.



    B165515
  1. Using a screwdriver, detach the 2 claws and remove the seat track cover.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE OUTER FRONT SEAT TRACK COVER RH REAR


    B165516
  1. Using a screwdriver, detach the 2 claws and remove the seat track cover.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE FRONT SEAT ASSEMBLY RH


    B165517
  1. Remove the 2 bolts.

  1. Operate the seat track adjusting handle to move the seat to the rearmost position.



    B165518
  1. Remove the 2 bolts.

  1. Operate the seat track adjusting handle to move the seat to the center position.

  1. Disconnect the seat wire connectors under the seat.

  1. Remove the front seat.

    NOTICE:
    Be careful not to damage the vehicle body.