Home › BODY › SEAT › FRONT POWER SEAT LUMBAR SWITCH (for Power Seat)

FRONT POWER SEAT LUMBAR SWITCH (for Power Seat) > INSPECTION

for Preparation Click here



1. INSPECT FRONT POWER SEAT LUMBAR SWITCH LH


B165793E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (B) - 4 (H)
    HOLD
    Below 1 Ω
    1 (R) - 2 (E2)
    1 (R) - 2 (E2)
    OFF
    4 (H) - 5 (E)
    1 (R) - 3 (B)
    RELEASE
    4 (H) - 5 (E)

    If the result is not as specified, replace the switch.



2. INSPECT FRONT POWER SEAT LUMBAR SWITCH RH


B165793E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (B) - 4 (H1)
    HOLD
    Below 1 Ω
    1 (R1) - 2 (E2)
    1 (R1) - 2 (E2)
    OFF
    4 (H1) - 5 (E)
    1 (R1) - 3 (B)
    RELEASE
    4 (H1) - 5 (E)

    If the result is not as specified, replace the switch.