Home › BODY › SEAT › LUMBAR SUPPORT ADJUSTER ASSEMBLY (for Manual Seat)

LUMBAR SUPPORT ADJUSTER ASSEMBLY (for Manual Seat) > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.



1. REMOVE FRONT SEAT ASSEMBLY LH
  1. Remove the front seat (Click here).



2. REMOVE VERTICAL ADJUSTING HANDLE LH (for 8 Way Seat)


    B165519
  1. Using a screwdriver, detach the 2 claws and remove the vertical adjuster handle cap.

    HINT:
    Tape the screwdriver tip before use.



    B165520
  1. Remove the 2 screws and vertical adjuster handle.



3. REMOVE VERTICAL SEAT ADJUSTER KNOB LH (for 8 Way Seat)


    B165522
  1. Remove the snap ring and vertical seat adjuster knob.



4. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH


B165521
  1. Lift the reclining adjuster release handle.

  1. Using a screwdriver, detach the claw and remove the reclining adjuster release handle.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE FRONT SEAT CUSHION SHIELD LH


    B165523E01
  1. Remove the hog rings and rubber bands of the seatback cover from the seat frame.



    B165524E01
  1. Remove the 2 screws.

  1. Detach the 3 claws in the order shown in the illustration, and then remove the cushion shield.

  1. w/ Lumbar Support Adjuster:
    Disconnect the switch connector.



6. REMOVE INNER FRONT SEAT CUSHION SHIELD LH


B165525E01
  1. Remove the screw.

  1. Detach the 3 claws in the order shown in the illustration, and then remove the cushion shield.



7. REMOVE FRONT SEAT HEADREST ASSEMBLY LH


8. REMOVE FRONT SEATBACK COVER WITH PAD LH


    B165530E01
  1. Detach the hook.



    B165531E01
  1. Remove the hog rings and seatback cover wires.



    B165533
  1. Remove the nut and seatback cover bracket from the seat frame.



    B165529
  1. Detach the 4 claws and remove the 2 headrest supports.



    B165534E01
  1. Remove the hog rings and seatback cover with pad.



9. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH


    B167105E04
  1. Remove the 2 springs.

  1. Detach the 6 hooks and remove the seatback spring.



    B167109
  1. Disconnect the lumbar support adjuster connector.

  1. Remove the 2 screws and lumbar support adjuster.