SHIFT LEVER ASSEMBLY (for Floor Shift Type) > DISASSEMBLY |
| 1. REMOVE INDICATOR LIGHT WIRE SUB-ASSEMBLY |
![]() |
Using a thin-bladed screwdriver, release the connector housing retainer.
Using a thin-bladed screwdriver, push out terminals 4 (ILL+) and 8 (ILL-) from the rear as shown in the illustration.
![]() |
Rotate the indicator light wire counterclockwise to align the wire with the key part of the transmission floor shift assembly and remove the wire.
| 2. REMOVE SHIFT LOCK RELEASE BUTTON |
![]() |
Detach the 4 claws and remove the position indicator housing from the floor shift.
![]() |
Detach the 2 claws and remove the button.
| 3. REMOVE SHIFT LOCK CONTROL ECU |
![]() |
Disconnect the shift lock solenoid connector.
Detach the 3 claws and remove the ECU.