Home › ENGINE ยท 1GR-FE › ENGINE MECHANICAL › CYLINDER BLOCK

CYLINDER BLOCK > REPLACEMENT

for Preparation Click here



1. REPLACE STRAIGHT PIN


NOTICE:
It is not necessary to remove a straight pin unless it is being replaced.



A224781E01


Text in Illustration 
*A
Front Side
*B
Rear Side
*C
Upper Side
*D
Lower Side
  1. Remove the straight pins.

  1. Using a plastic-faced hammer, tap in new straight pins to the cylinder block.

    Standard Protrusion Height:

    Item
    Specified Condition
    Pin A
    22.5 to 23.5 mm (0.886 to 0.925 in.)
    Pin B
    10.5 to 11.5 mm (0.413 to 0.453 in.)
    Pin C
    8.5 to 9.5 mm (0.335 to 0.374 in.)
    Pin D
    5.5 to 6.5 mm (0.217 to 0.256 in.)