Home
›
BODY
›
EXTERIOR
›
SIDE MOULDING
SIDE MOULDING > REMOVAL
for Preparation
Click here
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
When removing the moulding, heat the vehicle body and moulding using a heat light.
Standard heating temperature:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Moulding
20 to 30°C (68 to 86°F)
NOTICE:
Do not heat the vehicle body and moulding excessively.
1. REMOVE LOWER NO. 1 SIDE PANEL MOULDING LH
Detach the 2 clips and remove the moulding.