DTC P060E Internal Control Module Throttle Position Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P060E | When either condition below is met:
| ECM |
| Related DTCs | None |
| Required Sensors/Components (Main) | ECM |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Once per driving cycle |
| Duration | 1 second |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | None |
| Monitor runs whenever following DTCs not present | None |
| DMA communication error | Not detected |
| Difference of main TP and sub TP | 0.3 V or more |
| Difference of main brake switch signal and sub brake switch signal | Different |

| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK DTC |
Clear DTC (Click here).
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Turn the ignition switch to ON.
Wait 16 seconds or more.
Check DTC.
|
| ||||
| OK | ||
| ||