Home › BODY ELECTRICAL › LIGHTING › FOG LIGHT RELAY

FOG LIGHT RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE FOG LIGHT RELAY (FOG)


    E145695
  1. Remove the fog light relay from the engine room relay box.



2. INSPECT FOG LIGHT RELAY


E145692E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    When battery voltage is not applied to terminals 1 and 2
    10 kΩ or higher
    When battery voltage is applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the relay.



3. INSTALL FOG LIGHT RELAY