Home › ENGINE · 3UR-FE › FUEL › FUEL SENDER GAUGE ASSEMBLY

FUEL SENDER GAUGE ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FUEL SENDER GAUGE ASSEMBLY


A156397E01
  1. Check that the float moves smoothly between F and E.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    2 - 3
    Float level is F (upper)
    12 to 18 Ω
    Float level is E (lower)
    405 to 415 Ω

    If the result is not as specified, replace the fuel sender gauge assembly.