Home › BODY › WINDSHIELD / WINDOWGLASS › WINDSHIELD DEICER SYSTEM

WINDSHIELD DEICER SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK AIR CONDITIONING AMPLIFIER

B160781E01

  1. Disconnect the J19 air conditioning amplifier connector.

  2. Measure the resistance and voltage according to the value(s) in the table below.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    J19-1 (IG+) - J19-14 (GND)
    P - W-B
    Ignition power supply
    Ignition switch ON
    11 to 14 V
    Ignition switch OFF
    Below 1 V
    J19-21 (B) - J19-14 (GND)
    R - W-B
    Battery power source
    Always
    11 to 14 V
    J19-37 (LIN1) - J19-14 (GND)
    SB - W-B
    LIN communication signal
    Ignition switch ON
    Pulse generation
    J19-14 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω

    1. If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the J19 air conditioning amplifier connector.

  4. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    J19-40 (D) - J19-14 (GND)
    GR - W-B
    Deicer relay
    Ignition switch ON
    Deicer switch OFF
    11 to 14 V
    Ignition switch ON
    Deicer switch ON
    Below 1 V

    1. If the result is not as specified, the air conditioning amplifier or fuse may have a malfunction.


CHECK INTEGRATION CONTROL AND PANEL

B160782E01

  1. Disconnect the J37 integration control and panel connector.

  2. Measure the resistance and voltage according to the value(s) in the table below.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    J37-16 (IG+) - J37-1 (GND)
    P - W-B
    Ignition power supply
    Ignition switch OFF
    Below 1 V
    Ignition switch ON
    11 to 14 V
    J37-3 (STX) - J37-1 (GND)
    SB - W-B
    LIN communication circuit
    Ignition switch ON
    Pulse generation
    J37-1 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω

    1. If the result is not as specified, there may be a malfunction on the wire harness side.