THEFT DETERRENT SYSTEM > Engine Hood Courtesy Switch Circuit |

| 1.READ VALUE USING TECHSTREAM (ENGINE HOOD COURTESY SWITCH) |
Using the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Hood Courtesy Switch | Engine hood courtesy switch / ON or OFF | ON: Engine hood is open OFF: Engine hood is closed | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH) |

Remove the hood lock (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | UNLOCK position | Below 1 Ω |
| LOCK position | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ENGINE HOOD COURTESY SWITCH AND BODY GROUND) |
![]() |
Disconnect the J4 main body ECU connector.
Disconnect the A29 engine hood courtesy switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J4-16 (HCTY) - A29-1 | Always | Below 1 Ω |
| A29-2 - Body ground | ||
| J4-16 (HCTY) or A29-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||