Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > SYSTEM DESCRIPTION



OUTLINE OF THEFT DETERRENT SYSTEM
  1. The theft deterrent system is designed to deter vehicle break-ins and theft. If an attempted break-in or theft is detected, the vehicle horns and security horn will sound and the hazard warning lights will flash.

  2. The system detects an attempted break-in or theft when any of the following occurs: 1) the vehicle is forcibly entered, 2) the engine hood is forcibly opened, 3) the doors are unlocked without the use of a key, or 4) the cable from the negative (-) battery terminal is disconnected and reconnected.

  3. If the system enters the alarm sounding state, any unlocked doors will automatically lock.

  4. The system has 2 modes: active arming mode (refer to "ACTIVE ARMING MODE") and passive arming mode (refer to "PASSIVE ARMING MODE"). Passive arming mode can be turned on and off using the Techstream.

  5. Each mode has 4 states: disarmed state, arming preparation state, armed state and alarm sounding state.

    1. Disarmed state:

      1. The alarm function is not operating.
      2. The theft deterrent system is not operating.

    2. Arming preparation state:

      1. The theft deterrent system is not operating.

    3. Armed state:

      1. The theft deterrent system is operating.

    4. Alarm sounding state:

      1. The alarm function is operating (60 +/-5 seconds).

      Refer to table below for alarm method and time 
      Alarm Method
      Hazard Warning Light
      Blinking (cycle of flasher relay)
      Vehicle Horn
      Sounding (cycle of 0.4 seconds)
      Security Horn
      Sounding (cycle of 0.4 seconds)
      Headlight
      Flashing
      Taillight
      Flashing
      Room light
      Illuminating
      Security Indicator
      Illuminating
      Alarm Time
      60 +/-5 seconds

      HINT:
      If, during the alarm sounding state, one of the doors is unlocked without using the proper key, a forced door lock signal will be output (refer to "FORCED DOOR LOCK CONTROL").


FUNCTION OF MAIN COMPONENT

Function
Outline
Security indicator
Informs driver of theft deterrent system status
Security horn
Sounds when attempted brake-in or theft is detected
Taillight
Taillights illuminate if system enters alarm sounding state when system is unset
Hazard warning light
Hazard warning lights begin flashing when attempted break-in or theft is detected
Vehicle horns
Sounds when attempted break-in or theft is detected
Door courtesy light switch
Detects door open status (open or closed)
Door unlock detection switch
Detects door unlock status
Engine hood courtesy switch
Detects engine hood open status (open or closed)
Main body ECU
Detects ignition switch condition (OFF, ON, ACC or engine running)
Glass breakage sensor ECU*
Glass breakage sensor ECU outputs alarm request signal to main body ECU when sound of glass breaking is detected

HINT:
*: w/ Glass Breakage Sensor


SYSTEM FUNCTION
  1. Disarmed state:

    1. The alarm function is not operating.
    2. The theft deterrent system is not operating.

  2. Arming preparation state:

    1. The theft deterrent system is not operating.

  3. Arming state:

    1. The theft deterrent system is operating.

  4. Alarm sounding state:

    1. The alarm function is operating (60 +/-5 seconds).