Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > CUSTOMIZE PARAMETERS



CUSTOMIZING FUNCTION WITH TECHSTREAM

NOTICE:
  1. When the customer requests a change in a function, first make sure that the function can be customized.
  2. Be sure to make a note of the current settings before customizing.
  3. When troubleshooting a function, first make sure that the function is set to the default setting.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch ON.

  3. Turn the Techstream on.

  4. Enter the following menus: Customize Setting.

  5. Select the setting by referring to the table below.

    Main Body 
    Display
    Default
    Contents
    Setting
    Warning by Horn
    ON
    Function that allows vehicle horns and theft deterrent horn to be used as warning device.
    ON or OFF
    Passive Mode (Security system)
    OFF
    Passive arming mode is function that switches theft deterrent system from arming preparation state to armed state 30 seconds after key is not inside vehicle and driver side door is closed.
    In passive arming mode, theft deterrent system will judge that theft is taking place and switch to alarm sounding state if one of following operations are not performed within 14 seconds (see entry delay below) after door is opened:
    1. Unlock any door by key or wireless operation
    2. Turn ignition switch ON
    ON or OFF
    Entry Delay
    14 s
    Function that changes entry delay time (time before warning starts) for PASSIVE ARMING MODE
    0 s / 14 s / 30 s
    Warning by Glass Broken Sensor*
    ON
    Function that turns glass breakage sensor ON/OFF.
    This function is only effective for vehicles with glass breakage sensor.
    ON or OFF

    HINT:
    *: w/ Glass Breakage Sensor