Home › ENGINE · 1UR-FE › STARTING › ACC CUT RELAY

ACC CUT RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE ACC CUT RELAY
  1. Remove the clip.

  1. Detach the 2 clips and remove the cowl side trim board RH.

  1. Remove the relay.



2. INSPECT ACC CUT RELAY


    A087121E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester connection
    Condition
    Specified Condition
    3 - 4
    When battery voltage is not applied to terminals 1 and 2
    Below 1 Ω
    When battery voltage is applied to terminals 1 and 2
    10 kΩ or higher

    If the result is not as specified, replace the relay.



3. INSTALL ACC CUT RELAY
  1. Install the relay.

  1. Attach the 2 clips to install the cowl side trim board RH.

  1. Install the clip.