Home › BODY › ENGINE HOOD / DOOR › REAR DOOR (for CrewMax)

REAR DOOR (for CrewMax) > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



3. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH


    B166242
  1. Using a screwdriver, detach the 4 claws and remove the inside handle bezel.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE REAR UPPER DOOR ARMREST BASE PANEL LH


    B166243
  1. Using a screwdriver, detach the 2 clips and rear upper door armrest base panel. Then disconnect the connector.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY


    B166733
  1. Detach the 4 claws and remove the power window regulator switch.



6. REMOVE REAR DOOR FRAME GARNISH LH


    B169253
  1. Detach the 5 clips and remove the rear door frame garnish.



7. REMOVE REAR DOOR ARMREST COVER LH


8. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    B169254E01
  1. Remove the 2 screws.

  1. Using a clip remover, remove the clip.

  1. for Standard:

    1. Detach the 10 clips and remove the trim board.

  1. for 12 Speakers:

    1. Detach the 10 clips and remove the trim board. Then disconnect the connector.



    B165654E01
  1. Disconnect the 2 cables from the inside handle.

  1. Remove the inside handle.



9. REMOVE REAR NO. 2 SPEAKER ASSEMBLY (for 12 Speakers)


B169722
  1. Detach the 3 claws and remove the speaker.



10. REMOVE REAR INNER DOOR GLASS WEATHERSTRIP LH


11. REMOVE REAR NO. 2 DOOR TRIM BRACKET


    B169255
  1. Remove the 2 screws and bracket.



12. REMOVE REAR SPEAKER ASSEMBLY



B165745E02

  1. Disconnect the speaker connector.

  1. Remove the 3 screws and speaker.

    NOTICE:
    Do not touch the cone part of the speaker.



13. REMOVE REAR DOOR SERVICE HOLE COVER LH


    B169256
  1. Disconnect the connector and 5 clamps.

  1. Remove the rear door service hole cover.

    HINT:
    Remove the remaining tape on the door.



14. REMOVE REAR DOOR GLASS RUN LH


    B169257
  1. Remove the rear door glass run.



15. REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH


    B169259
  1. Remove the 2 bolts and rear door rear lower window frame.

    HINT:
    Remove the frame through the service hole.

    NOTICE:
    Be careful when removing the bolts as the frame may fall and become damaged.



16. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH


B169260
  1. Temporarily install the power window regulator switch.

  1. Move the door glass until the bolts appear in the service holes.

  1. Remove the 2 bolts.

    NOTICE:
    Be careful when removing the bolts as the glass may fall and become damaged.

  1. Remove the rear door glass from the rear door window regulator as shown in the illustration.

    NOTICE:
    Do not damage the door glass.

  1. Remove the power window regulator switch.



17. REMOVE REAR DOOR FRONT WINDOW GUIDE SUB-ASSEMBLY LH


    B169261
  1. Remove the 2 bolts and rear lower front door window guide.

    HINT:
    Remove the frame through the service hole.

    NOTICE:
    Be careful when removing the bolts as the frame may fall and become damaged.



18. REMOVE REAR NO. 2 DOOR GLASS RUN LH
  1. Remove the rear door glass run from the rear front lower door window guide.



19. REMOVE REAR OUTER DOOR GLASS WEATHERSTRIP


B169236E02
  1. Put protective tape around the weatherstrip outer.

  1. Using a moulding remover, detach the claw and remove the weatherstrip.



20. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH


    B169262E01
  1. Disconnect the connector.

  1. Loosen the temporary bolt.

    NOTICE:
    Do not remove the temporary bolt. If the temporary bolt is removed, the front door window regulator may fall and become damaged.

  1. Remove the 5 bolts and window regulator.

  1. Remove the window regulator through the service hole.

  1. Remove the temporary bolt from the door window regulator.



21. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH


    B165662
  1. Using a T25 "TORX" driver, remove the 3 screws and motor.

    NOTICE:
    Be careful when removing the screws as the motor may fall and become damaged.



22. REMOVE REAR DOOR LOCK ASSEMBLY LH


    B169263
  1. Disconnect the connector.

  1. Using a T30 "TORX" wrench, remove the 3 screws and door lock.

    HINT:
    Remove the door lock through the service hole.

    NOTICE:
    Be careful when removing the bolts as the door lock may fall and become damaged.



23. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH


    B169265
  1. Using a screwdriver, detach the claw.



    B169264E01
  1. Remove the rear door lock remote control cable.



24. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH


    B167681
  1. Using a screwdriver, detach the 3 claws.

    HINT:
    Tape the screwdriver tip before use.



    B167682E01
  1. Remove the rear door inside locking cable.



25. REMOVE REAR DOOR LOCK CHILD PROTECTION COVER LH


26. REMOVE REAR DOOR OUTSIDE HANDLE COVER LH


    B170110
  1. Remove the hole plug.

  1. Using a T30 "TORX" wrench, loosen the screw and remove the rear door outside handle cover.

  1. Remove the cover.



27. REMOVE REAR DOOR OUTSIDE HANDLE ASSEMBLY LH


    B169268
  1. Remove the handle by sliding and pulling it in the direction indicated by the arrow in the illustration.

    NOTICE:
    If the release plate is not pulled and held when removing the handle, the release plate will interfere with the handle and become damaged.



28. REMOVE REAR DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY LH


    B169266
  1. Remove the front and rear outside handle pads .

  1. Using a T30 "TORX" wrench, loosen the screw.

  1. Slide the outside handle frame to remove it.

    HINT:
    Remove the outside handle frame through the service hole.



29. REMOVE REAR DOOR LOCK OPEN ROD LH
  1. Remove the lock open rod from the outside handle frame.



30. REMOVE REAR NO. 2 DOOR WEATHERSTRIP LH


    B169269
  1. Using a clip remover, detach the 10 clips and remove the weatherstrip.

    HINT:
    If clips are damaged during removal, replace them.



31. REMOVE REAR DOOR CHECK ASSEMBLY LH


    B166256
  1. Remove the bolt, 2 nuts and door check.

    HINT:
    Remove the door check through the service hole.

    NOTICE:
    Be careful when removing the bolts as the door check may fall and become damaged.



32. REMOVE REAR DOOR WEATHERSTRIP LH


    B170112
  1. Using a clip remover, detach the 2 clips.



    B169270
  1. Using a clip remover, detach the 41 clips and remove the weatherstrip.

    HINT:
    If clips are damaged during removal, replace them.