Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › CLEARANCE WARNING ECU

CLEARANCE WARNING ECU > INSTALLATION

for Preparation Click here


HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL CLEARANCE WARNING ECU ASSEMBLY


    E188109
  1. Install the clearance warning ECU to the bracket with the 2 nuts.

    NOTICE:
    1. Avoid any impact to the clearance warning ECU.
    2. Do not drop the ECU. If it is dropped, replace it with a new one.



2. INSTALL CLEARANCE WARNING ECU WITH BRACKET


    E188108
  1. Install the ECU with bracket with the nut and bolt.

  1. Connect the ECU connectors and attach the harness clamp.

    NOTICE:
    Do not apply excessive force to the wire harnesses.



3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH


    B230430
  1. Connect the connector.



    B226741
  1. Attach the 3 claws to install the finish panel.

  1. Install the 3 screws.

  1. Install the bolt.



4. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B226008
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Install the 3 bolts to install the instrument panel airbag.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



5. INSTALL LOWER INSTRUMENT PANEL


    B226759
  1. Attach the 2 claws.

  1. Install the panel with the bolt and screw.



6. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B226758
  1. Attach the 2 guides.

  1. Attach the 4 claws and clip to install the panel.



7. INSTALL INSTRUMENT SIDE PANEL RH


    B229198
  1. Attach the 6 claws to install the side panel.



8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


9. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light .