CLEARANCE WARNING ECU > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE INSTRUMENT SIDE PANEL RH |
![]() |
Using a moulding remover, detach the 6 claws and remove the side panel.
| 4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
![]() |
Detach the clip and 4 claws.
Detach the 2 guides and remove the panel.
| 5. REMOVE LOWER INSTRUMENT PANEL |
![]() |
Remove the screw and bolt.
Detach the 2 claws and remove the panel.
| 6. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY |
![]() |
Remove the 3 bolts and remove the instrument panel airbag.
Disconnect the connector.
| 7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH |
![]() |
Remove the bolt.
Remove the 3 screws.
Detach the 3 claws and remove the finish panel.
![]() |
Disconnect the connector.
| 8. REMOVE CLEARANCE WARNING ECU WITH BRACKET |
![]() |
Disconnect the ECU connectors and detach the harness clamp.
Remove the bolt, nut and ECU with bracket.
| 9. REMOVE CLEARANCE WARNING ECU ASSEMBLY |
![]() |
Remove the 2 nuts and clearance warning ECU from the bracket.