FRONT DOOR LOCK (for CrewMax) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH |
![]() |
Using a screwdriver, detach the 4 claws and remove the inside handle bezel.
| 4. REMOVE FRONT ARMREST UPPER BASE PANEL LH |
![]() |
Using a screwdriver, detach the 2 clips and front upper armrest base panel.
Disconnect the connectors.
| 5. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH |
![]() |
Detach the 3 clips and remove the front lower door frame bracket garnish.
| 6. REMOVE FRONT DOOR ARMREST COVER LH |
| 7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH |
![]() |
Remove the 2 screws.
Remove the clip.
Detach the 9 clips and remove the trim board cover. Then disconnect the connector.
![]() |
Disconnect the 2 cables from the inside handle.
Remove the inside handle.
| 8. REMOVE FRONT NO. 1 DOOR TRIM BRACKET |
![]() |
Remove the 2 screws and bracket.
| 9. REMOVE FRONT DOOR SERVICE HOLE COVER LH |
![]() |
Using a clip remover, detach the 2 clamps.
![]() |
Remove the front door service hole cover.
| 10. REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH |
![]() |
Remove the 2 bolts and front door rear lower frame.
| 11. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH |
for Driver Side:
Temporarily install the power window regulator master switch.
for Passenger Side:
Temporarily install the power window regulator switch.
Connect the cable to the negative (-) battery terminal.
![]() |
Move the door glass until the bolts appear in the service holes.
Remove the 2 bolts.
![]() |
Remove the door glass in the direction indicated by the arrows in the illustration.
for Driver Side:
Remove the power window regulator master switch.
for Passenger Side:
Remove the power window regulator switch.
Disconnect the cable from the negative (-) battery terminal.
| 12. REMOVE FRONT DOOR LOCK ASSEMBLY LH |
![]() |
Disconnect the connector.
Using a T30 "TORX" wrench, remove the 3 screws and door lock.
| 13. REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH |
![]() |
Remove the front door lock remote control cable.
| 14. REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH |
![]() |
Using a screwdriver, detach the 3 claws.
![]() |
Remove the front door inside locking cable.