Home › STEERING › STEERING COLUMN › STEERING COLUMN ASSEMBLY (for Manual Tilt)

STEERING COLUMN ASSEMBLY (for Manual Tilt) > INSPECTION

for Preparation Click here



1. INSPECT STEERING COLUMN ASSEMBLY


    C155152E02
  1. Measure the length of the steering main shaft.

    Standard length (A):
    529.5 mm (1.74 ft.)



  1. Inspect the bushings.



      C244198E01
    1. Check that the 2 bushings are securely installed to the steering column assembly.
      Text in Illustration 
      *1
      Bushing
      If the bushings are missing or damaged, replace the steering column assembly with a new one.

    2. Check the 2 bushings for deformation and damage.
      If the bushings are deformed or damaged, replace the steering column assembly with a new one.



  1. Inspect the capsules.



      C243653E01
    1. Check that the 2 capsules are securely installed to the steering column assembly as shown in the illustration.

      Standard Dimension:
      A
      B
      3 mm (0.118 in.)
      10 mm (0.394 in.)

      If the capsules are not positioned as specified, replace the steering column assembly with a new one.

    2. Check the 2 capsules for deformation and damage.
      If either of the capsules is deformed, loose, missing or damaged, replace the steering column assembly with a new one.