FENDER LINER (for Front Side) > INSTALLATION |
| 1. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH |
![]() |
for Steel Type Bumper:
Install the front fender splash shield.
Install the fender splash shield with the 2 screws, clip and 2 new clips labeled A.
![]() |
for Resin Type Bumper:
Install the front fender splash shield.
Install the fender splash shield with the 2 screws and 2 clips.
Install the pin hold clip so that its groove is vertical.
| 2. INSTALL FENDER APRON MUDGUARD SEAL LH |
for Steel Type Bumper:
Install the fender apron mudguard seal.
Install the fender apron mudguard with the 3 clips and 15 new clips labeled A.

w/ Front Fender Mudguard:
Install the front fender mudguard .
w/ Side Step:
Install the side step .
for Resin Type Bumper:
Install the fender apron mudguard seal.
Install the fender apron mudguard with the 2 clips and 15 new clips labeled A.
Install the pin hold clip so that its groove is vertical.

w/ Front Fender Mudguard:
Install the front fender mudguard .
w/ Side Step:
Install the side step .