Home › BODY ELECTRICAL › AUDIO / VISUAL › FRONT DOOR SPEAKER (for Regular Cab)

FRONT DOOR SPEAKER (for Regular Cab) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY


B166269E01
  1. Temporarily install the speaker by attaching the claws of the speaker to the door panel.

  1. Install the speaker with the 4 screws.

    NOTICE:
    Do not touch the cone part of the speaker.

    HINT:
    Install the screws in the order shown in the illustration.

  1. Connect the connector.



2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    B165684E03
  1. Connect the 2 cables to the inside handle.

  1. Attach the inside handle's knob to the door trim board.

  1. Attach the 10 clips to install the door trim board.



    B167314E01
  1. Install the inside handle and door trim board to the door trim panel with the screw.

  1. Install the door trim board to the door panel with the screw.

  1. Attach the clip.



3. INSTALL FRONT DOOR ARMREST COVER LH


4. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


    B165697E01
  1. Install the plate and regulator handle with the snap ring.

    HINT:
    With the door window fully closed, install the plate and the regulator handle with the snap ring as shown in the illustration.



5. INSTALL FRONT UPPER ARMREST BASE PANEL LH (w/ Power Window)


    B165649E01
  1. Connect the connectors.

  1. Attach the 2 clips to install the front upper armrest base panel.



6. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH


    B165648E01
  1. Attach the 4 claws to install the bezel plug.



7. INSTALL FRONT LOWER DOOR FRAME BRACKET GARNISH LH


    B165652
  1. Attach the 3 clips to install the front lower door frame bracket garnish.



8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL