Home › BODY ELECTRICAL › AUDIO / VISUAL › FRONT DOOR SPEAKER (for Regular Cab)

FRONT DOOR SPEAKER (for Regular Cab) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH


    B165652
  1. Detach the 3 clips and front lower door frame bracket garnish.



4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH


    B165648
  1. Using a screwdriver, detach the 4 claws and remove the inside handle bezel.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE FRONT UPPER ARMREST BASE PANEL LH (w/ Power Window)


    B165649
  1. Using a screwdriver, detach the 2 clips and front upper armrest base panel.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connectors.



6. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


    B084267E03
  1. Insert a clip remover between the plate and trim.

  1. Turn the handle clockwise to remove the handle.



7. REMOVE FRONT DOOR ARMREST COVER LH


8. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    B167314E01
  1. Remove the 2 screws.

  1. Using a clip remover, remove the clip.

  1. Detach the 10 clips and remove the trim cover. Then disconnect the connector.



    B165654E01
  1. Disconnect the 2 cables from the inside handle.

  1. Remove the inside handle.



9. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY


B165746
  1. Disconnect the speaker connector.

  1. Remove the 4 screws and speaker.

    NOTICE:
    Do not touch the cone part of the speaker.