Home › BODY ELECTRICAL › AUDIO / VISUAL › REAR DOOR SPEAKER (for Double Cab)

REAR DOOR SPEAKER (for Double Cab) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. INSTALL REAR NO. 1 SPEAKER ASSEMBLY



B166268E01

  1. Temporarily install the speaker by attaching the claws of the speaker to the door panel.

  1. Install the speaker with the 3 screws.

    NOTICE:
    Do not touch the cone part of the speaker.

    HINT:
    Install the screws in the order shown in the illustration.

  1. Connect the connector.



2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    B165684E03
  1. Connect the 2 cables to the inside handle.

  1. Attach the inside handle's knob to the door trim board.



    B166244E01
  1. Attach the 9 clips to install the door trim board.

  1. Install the inside handle and door trim board to the door trim panel with the screw.

  1. Install the door trim board to the door panel with the screw

  1. Attach the clip.



3. INSTALL REAR DOOR ARMREST COVER LH


4. INSTALL REAR UPPER DOOR ARMREST BASE PANEL LH


    B168094
  1. Connect the connector.

  1. Attach the 2 clips to install the rear upper door armrest base panel.



5. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH


    B168093
  1. Attach the 4 claws to install the bezel plug.



6. INSTALL REAR DOOR FRAME GARNISH LH


    B167090
  1. Attach the 4 clips to install the rear door frame garnish.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL